Zx10R Cooling Fan Not Working at Alma Sato blog

Zx10R Cooling Fan Not Working. with my friend i troubleshooted the fan wiring from the fan to the battery, and there was a spot where the power. is your coolant level very low? Then i tried to check if the fan. The fan should be tested, bypassing any sensors to make sure it is. If not, then your fan motor isn't working. It's a lubricant used when you run water only. It might not be high enough to contact the sensor. it does not increase the cooling capability of anything! if the fuse is intact and the temperature sensor is displaying an accurate reading on the dash then it would most likely be a. if it's not low and the fuses are good, the relay is working: It could be due to. if the fan turns on with the 12v you tested with than the relay is not being activated by the ecu. put power directly to the fan and see if it turns on. First i checked the fuse : i noticed that the fan was not coming on.

It's a lubricant used when you run water only. Then i tried to check if the fan. if it's not low and the fuses are good, the relay is working: It might not be high enough to contact the sensor. First i checked the fuse : with my friend i troubleshooted the fan wiring from the fan to the battery, and there was a spot where the power. is your coolant level very low? put power directly to the fan and see if it turns on. if the fan turns on with the 12v you tested with than the relay is not being activated by the ecu. it does not increase the cooling capability of anything!

06 07 2006 2007 Kawasaki Ninja Zx10r Engine Radiator Cooling Fan Motor

Zx10R Cooling Fan Not Working It might not be high enough to contact the sensor. it does not increase the cooling capability of anything! First i checked the fuse : It might not be high enough to contact the sensor. if the fuse is intact and the temperature sensor is displaying an accurate reading on the dash then it would most likely be a. i noticed that the fan was not coming on. The fan should be tested, bypassing any sensors to make sure it is. is your coolant level very low? with my friend i troubleshooted the fan wiring from the fan to the battery, and there was a spot where the power. It could be due to. put power directly to the fan and see if it turns on. It's a lubricant used when you run water only. if it's not low and the fuses are good, the relay is working: if the fan turns on with the 12v you tested with than the relay is not being activated by the ecu. Then i tried to check if the fan. If not, then your fan motor isn't working.